Sign up for email updates on regulations for this and other products
The Energy Policy and Conservation Act, as amended, 42 U.S.C. 6291–6309 (EPCA) establishes energy conservation or water use standards and test procedures for certain consumer products, including urinals. Title 10 of the Code of Federal Regulations, Part 430 (10 CFR 430), defines the term “urinal” to mean a plumbing fixture that receives only liquid body waste and, on demand, conveys the waste through a trap seal into a gravity drainage system, except such term does not include fixtures designed for installation in prisons. (10 CFR 430.2) The Department of Energy (DOE) last amended the test procedures for urinals on September 30, 2013. Under the provisions of 42 U.S.C. 6295(k)(3), the water use standards for urinals have not been amended.
For the latest information on the planned timing of future DOE regulatory milestones, see the current Office of Management and Budget Unified Agenda of Regulatory and Deregulatory Actions. All planned dates are preliminary and subject to change.
Standards
The Energy Policy Act of 1992 amended EPCA to add water conservation standards for urinals, based on the flush volume requirements contained in American Society of Mechanical Engineers (ASME)/American National Standards Institute (ANSI) Standard A112.19.6-1990, which are codified under Title 42 of the U.S. Code (42 U.S.C.) section 6295(k). Under 42 U.S.C. 6295(k)(3), if the flush volume requirements contained in ASME/ANSI Standard A112.19.6 are amended to improve efficiency of water use, the Secretary of Energy shall consider establishing an amended uniform national standard at the level specified in the amended ASME/ANSI Standard. To date, ASME has not updated the flush volume requirements for urinals.
Public Meeting Information
There is no public meeting scheduled at this time.
Submitting Public Comments
The comment period is closed.
Test Procedure
Final Rule - Federal Register, 87FR16375 (March 23, 2022)
Notice of Proposed Rulemaking - Federal Register, 86FR27281 (May 20, 2021)
Notice of Data Collection - Federal Register, 84FR37970 (August 5, 2019)
The urinals test procedure rulemaking docket EERE-2017-BT-TP-0028 contains pertinent notices, public comments, public meeting transcripts, and supporting documents.
Public Meeting Information
There is no public meeting scheduled at this time.
Submitting Public Comments
Comment period is closed.
The flush rate of a urinal manufactured and distributed in commerce, as defined by 42 U.S.C. 6291(10) and (16) respectively, must be not greater than the maximum water use standards under 10 CFR 430.32(r).
To determine whether a urinal is in compliance with the water consumption standards under 10 CFR 430(r), a manufacturer must measure the maximum flush volume in accordance with 10 CFR 430, Appendix T to Subpart B.
Compliance
DOE has established regulations on certification, compliance, and enforcement in 10 CFR Part 429. These regulations cover statistical sampling plans, certified ratings, certification reports, record retention, and enforcement. More information about compliance and enforcement is available on DOE's Implementation webpage.
Waivers
For information on current test procedure waivers, see DOE’s Waivers webpage.
For information about obtaining test procedure waivers, see 10 CFR 430.27.
Exceptions
DOE's Office of Hearings and Appeals has not authorized exception relief for urinals.
For information about obtaining exception relief, see 10 CFR part 1003.
Guidance and Frequently Asked Questions
For information on further guidance and answers to frequently asked questions on all covered products, see DOE’s Further Guidance database.
State Exemptions to Federal Pre-emption
A state may petition DOE for exemption from preemption of a federal water conservation standard in certain cases of unusual or compelling state or local water interests. A state may also petition DOE to withdraw such exemption. See 10 CFR part 430, subpart D. DOE has not exempted any state from this water conservation standard.
On December 22, 2010, DOE published in the Federal Register a final rule to waive the general rule of federal preemption for water use standards, under 42 U.S.C. 6297(c), with respect to any state regulation concerning urinals if such state regulation is (1) more stringent than federal regulation concerning the water use or water efficiency for that same type or class of product, and (2) applicable to any sale or installation of all products in that particular type or class. 75 FR 80289.
Small Business Exemptions
Any manufacturer of a covered product with annual gross revenues that do not exceed $8,000,000 from all its operations and meets certain other conditions may apply for an exemption to the energy conservation standard. For details, see 10 CFR part 430, subpart E.
ENERGY STAR®
DOE supports the testing and verification of ENERGY STAR products in close collaboration with the Environmental Protection Agency.
Find tips and guidance for making your home, workplace, or vehicle more energy efficient visit EnergySavers.gov.
For more information related to this product, please email:
ApplianceStandardsQuestions@ee.doe.gov