Add Blanks in CHEX Ductwork Between FLT-7 and FLT-8 and Remove Out-of-Service OGE Ducting CX(s) Applied: B2.3Date: 02/05/2015 Location(s): South CarolinaOffices(s): Savannah River Operations Office
Office of NEPA Policy and Compliance
February 5, 2015
Estimated Read Time min
Add Blanks in CHEX Ductwork Between FLT-7 and FLT-8 and Remove Out-of-Service OGE Ducting
CX(s) Applied: B2.3
Date: 02/05/2015
Location(s): South Carolina
Offices(s): Savannah River Operations Office
This activity removes the following ducting and piping from the CHEX system in B-005: two 1/8 inch thick by roughly 3 feet by 2 feet stainless steel spacers and their associated gaskets, approximately six feet of six inch diameter PVC piping used as ducting, and approximately 20 feet of 1/2" diameter pipe which served as sending lines to an out of service controller.