Dimensionally Stable High Performance MembraneCX(s) Applied: B3.6, B5.1Date: 09/14/2010Location(s): Newton, MassachusettsOffice(s): Energy Efficiency and Renewable Energy
Office of NEPA Policy and Compliance
September 14, 2010
Estimated Read Time min
CX(s) Applied: B3.6, B5.1
Date: 09/14/2010
Location(s): Newton, Massachusetts
Office(s): Energy Efficiency and Renewable Energy
In Phase III of the program, Giner Electrochemical Systems, LLC (GES) will take the molding methods that were generated in Phase II and apply them to a roll-good process. A number of different methods will be used to generate the molds. The Phase III tasks for scaling up the fabrication of patterned porous polymer membrane support structures using micro-molding technology is designed around six tasks: improve process parameters for Polydimethylsiloxane (PDMS) micromolding from the Phase II program; seek alternative molding methods; qualification of support substrates; micromolding process improvement; selection of scale-up method; and scale-up of bench process.